Product Overview

The Jandy Pro Series Levolor K2300CKC is an electronic water leveler that keeps two bodies of water topped off automatically. This dual kit pairs two level sensors with two 1" fill valves on 100 ft of sensor cable, so a pool and spa, or a pool and a water feature basin, can each be maintained on its own. The sensors mount anywhere the water sits at a steady level, such as a skimmer or a standpipe, and the controller opens the matching valve only when that level drops. The unit runs on 110 or 220 volts.

⚠️ Important Purchase Notice

This is an electrical control product. Installation should be done by a qualified pool technician or electrician following the Jandy installation manual and local codes. Inspect the shipment upon arrival and report damage promptly.

WARNING: This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Ideal For

• Pools with waterfalls, sheer descents, vanishing edges, or other features that lose water to splash and evaporation.
• Pool and spa combinations that each need their own fill control.
• Desert climates where daily evaporation is high.
• Adding automatic fill to an existing pad without cutting the deck.

Key Features

• Dual configuration: two sensors and two 1" valves.
• 100 ft of sensor cable for flexible equipment placement.
• Solid-state sensing with nothing mechanical to wear out or stick.
• Built-in fill timer that stops the valve if filling runs too long, helping prevent overflow and making leaks easier to spot.
• Sealed, water-resistant enclosure rated for equipment rooms.
• Works on 110V or 220V power.

Benefits

• Keeps water at the right level so skimmers and pumps don't run dry.
• Eliminates manual topping off with a hose.
• No deck-mounted fill canister or pressurized fill line under the deck.
• Fill time-out protects against wasted water from an unnoticed leak.

Compatibility

Designed for residential pool and spa systems, new or existing. The sensors install at any point with a stable water level, such as a skimmer or standpipe, and no changes to the pool shell or deck are required. Check your fill-water supply size against the 1" valves before ordering.

Installation or Upgrade Context

Mount the controller at the equipment pad, set each sensor where the water level is steady, route the sensor cables back to the controller, and plumb each 1" valve into its fill-water line. Wire the unit to 110V or 220V power per the manual, then test each zone and set the fill time-out.

What’s Included

• Levolor K2300 controller
• Two level sensors with 100 ft cable
• Two 1" fill valves

Specifications

Warranty

Covered by a one-year manufacturer warranty, subject to Jandy’s applicable terms. Contact Jandy for warranty claim instructions; Pool Supply Depot can provide proof of purchase.

Customer Q&A

Can one unit control a pool and a spa?

Yes. This dual model has two sensors and two valves, so each body of water fills independently.

Do I need to cut the deck to install it?

No. The sensors go in a skimmer or standpipe, and the controller and valves mount at the equipment pad.

What happens if there's a leak?

The fill timer shuts the valve off after a set time, so the unit won't keep filling endlessly and the leak is easier to notice.